Vortex Strike Eagle 5-25×56 Rifle Scope EBR-7C Reticle MOA
Strike Eagle 5-25×56 First Focal Plane Riflescope – EBR-7C (MOA) Reticle (SE-52503)
When you’re ready to step up your long-distance game, the Strike Eagle gives you more of the tools you need. Start with excellent edge-to-edge sharpness, and add a first focal plane illuminated reticle for fast reads at any magnification and lighting situation. Add in our RevStop Zero System for a hard return to zero, and locking turrets for fast, stay-put adjustments. Build it around a 34mm tube that accomodates massive amounts of elevation and windage travel, and add a throw lever for rapid magnification changes.
EBR-7C (MOA) Reticle
- A versatile reticle that fits comfortably no matter the application.
- First focal plane subtensions remain accurate at any range.
- Illuminated reticle eases use in low light and dark backgrounds.
- Fine holdover dots for fast wind and elevation holdovers.
Using the Riflescope
|
|
|
---|---|---|
Reticle FocusThe Strike Eagle scope uses a fast focus eyepiece designed to quickly and easily adjust the focus on the riflescope’s reticle. 1. Look through the riflescope at a blank white wall, or up at the sky. 2. Turn the eyepiece fully outward (counterclockwise). 3. Slowly turn the eyepiece focus knob inward until the reticle image is as crisp as possible. |
Parallax AdjustmentThis adjustment dial is marked with approximate yardages to aid in initial setting and should be matched to the target’s distance. Final focus setting should be checked by moving your head back and forth slightly while looking through the scope and watching for any shift of the reticle on the target (parallax). If shift is observed, the dial should be adjusted slightly until shift is removed. |
Turret AdjustmentsTo make turret adjustments: 1. Pull the Locking Turret dial up/out to disengage the lock. 2. Up/down for elevation adjustments; left/right for windage adjustments. 3. Push the Locking Turret dial down/in to return to the locked position. |
Indexing the Elevation Turret
|
|
|
|
---|---|---|---|
1. Remove the turret cap and gently pull the turret dial off the turret post, being careful not to rotate the post. |
2. Place the zero stop ring over turret post. Push the ring down then rotate the ring clockwise until it stops. |
3. Reinstall the turret dial, lining up the “0” mark with indexing line on the scope body. |
4. Replace and tighten the Elevation Turret cap. |
Reviews
There are no reviews yet.